General help and support for your Lindeman through 2010 John Deere crawler
-
tinkerer
- 420 crawler
- Posts: 32
- Joined: Thu Apr 07, 2005 8:26 pm
- Location: Middleburgh N.Y
Post
by tinkerer » Sat Apr 22, 2006 4:02 pm
Not having a tach on my 440 ic ,I would like to know what tach to use to set the govenor for the proper rpm. I used to have a tach&dwell, but it didn't have a setting for 2 cyl anyway , what do you guys use?
-
Lavoy
- Site Admin
- Posts: 10955
- Joined: Sun Apr 03, 2005 8:32 pm
- Location: North Dakota
-
Contact:
Post
by Lavoy » Sat Apr 22, 2006 4:39 pm
If you have a mechanical tach, you can read off of the PTO shaft, set it to about 600RPM. If you set a dwell meter to 4 cylinder, I think you would just double the reading.
lavoy
-
tinkerer
- 420 crawler
- Posts: 32
- Joined: Thu Apr 07, 2005 8:26 pm
- Location: Middleburgh N.Y
Post
by tinkerer » Sat Apr 22, 2006 5:08 pm
Thank you, but no pto ,you mite be rite about the 4 cyl setting and x by 2
-
tinkerer
- 420 crawler
- Posts: 32
- Joined: Thu Apr 07, 2005 8:26 pm
- Location: Middleburgh N.Y
Post
by tinkerer » Sat Apr 22, 2006 5:10 pm
Lavoy did you get my pm?.
-
Lavoy
- Site Admin
- Posts: 10955
- Joined: Sun Apr 03, 2005 8:32 pm
- Location: North Dakota
-
Contact:
Post
by Lavoy » Sun Apr 23, 2006 10:32 am
No, it does not appear to have worked, send me another one.
Lavoy
Who is online
Users browsing this forum: No registered users and 60 guests
