I need specs on a JD 2010 with 820 loader

Afzimm · Post by **Afzimm** » Thu May 26, 2011 7:33 pm

I am trying to ship a JD 2010 from the east coast to MN. Truckers need to know length, width and weight. No hoe, just machine and loader, oh and a 3 tooth ripper on the rear. If someone has a manual with measurements and weight specs you can call me at 320-583-2083. Thanks Al Z

[/img]

Pammark · Post by **Pammark** » Fri May 27, 2011 7:52 am

I can get a quick outside dimension for you. I have a 2010 with loader just like your picture. I have the added weights in the back and no scarfer, which may balance out. My dozer weighed in at 6.5 ton.

Afzimm · Post by **Afzimm** » Fri May 27, 2011 8:22 am

Mark. Best offer so far. I need that total length measurement. Al

Tigerhaze · Post by **Tigerhaze** » Fri May 27, 2011 8:31 am

This same question was asked a month or two ago- see my post about halfway down the second page of the thread below for dimensions as supplied by Deere:

http://www.jdcrawlers.com/messageboard/ ... 0&start=15

I'm a little suprised Willie asked for that information as he hauled a 2010 for me and didn't ask me those questions.

Afzimm · Post by **Afzimm** » Mon Jun 06, 2011 5:53 pm

Tiger

Willie has a full load of tractors coming from the east coast to MN and WI.
Thereason for the length was to see if he woulod be able to fit it on this trip. Al

JDcrawlers Messageboard

I need specs on a JD 2010 with 820 loader

I need specs on a JD 2010 with 820 loader

Who is online