![Image](http://i481.photobucket.com/albums/rr178/hydrogeo/photobucket-435702-1327858363876.jpg)
Napa stuff was a little pricey but there is no comparison in quality to the stuff Tractor Supply has. Runs fantastic now.
Then a trip to a logging supply place for a new 1/2 cable, a couple slides, and some chain chokers:
![Image](http://i481.photobucket.com/albums/rr178/hydrogeo/photobucket-10129-1327858296430.jpg)
After working it for a bit noticed a leak in the radiator. The previous owner did not have the radiator tin bolted down, so it must have worked at the filler neck causing the joint to leak. Figured I'd try some JB weld first before I went the hard route. So far so good:
![Image](http://i481.photobucket.com/albums/rr178/hydrogeo/photobucket-2736-1327858427174.jpg)
Finally the question. Somewhere along the line someone broke all the mounting tabs for the radiator guard on the front bolster.
![Image](http://i481.photobucket.com/albums/rr178/hydrogeo/photobucket-279789-1327858480181.jpg)
I'm not sure yet whether it is cast iron or cast steel. I was planning on just welding on some angle iron and drilling new bolt holes in the guard, but if it's iron I may drill through it and bolt on the angle iron. Any input on how best to attack this?