1010 reverser problems

[rogers05]

Need help i was using my 1010 to push some brush when i went to push the pedal it would not stop, i can shut the motor off and put it in any gear and crank it to move it just dont have a clutch pedal . The pedal just flops up and down with no pressure,i checked where the pedal goes in the reverser and there is no pin sheared any ideas. Thanks

[LarryD]

If it was working correctly and then suddenly it isn't, it sounds like something in the clutch linkage has broken. Look it all over from the pedal clear to the clutch fork. You should probably find something broken or fallen out of place due to wear between those extremes.

[whiteclipse16]

I don't know a lot about the 1010 but if it has the reverser I think the clutch is operated hydraulically. The pedal doesn't actually connect to the clutch through linkage like a 440 or later. The clutch pedal pushes a valve or something in the reverser.