I want to rebuild the four hydraulic cylinders on the loader, they don't leak but settle during operation. I have the spanner nut off of all four, the service manual says I need to tap the threaded end back slightly to remove the snap ring. I cannot get the end to move back into the cylinder, suspect it is corroded. I have hit it hard using a wood block and heavy hammer. Anyone have hints on getting the ends loose so I can pull the rams out?
Phil Fish, Middleton WI
Model 831 loader on 440IC
Re: Model 831 loader on 440IC
Light heat, not enough to vaporize and cause the oil to explode.
Lavoy
Lavoy
Parts and restoration for antique and late model John Deere crawlers.
Owner and moderator www.jdcrawlers.com
Owner and moderator www.jdcrawlers.com
Re: Model 831 loader on 440IC
Thank you very much!!
Who is online
Users browsing this forum: No registered users and 22 guests