General help and support for your Lindeman through 2010 John Deere crawler
-
kyboy
- 40C crawler
- Posts: 12
- Joined: Thu Sep 13, 2007 5:00 am
- Location: st paul ky
Post
by kyboy » Mon Oct 08, 2007 5:36 pm
Do you have any pressure plates in stock.what are the prices? new,rebuilt,or used? i have an exchange,it only has 1 spring under the fingers. the book shows 2. i think they sold us the wrong one when we got these two. the other seems ok.(it;s the only one that pulls like it should. how much is shipping to zip 41166,quincy ky.give me all the info you can.
look forward to hearing from you.
Gary Blaine
-
Lavoy
- Site Admin
- Posts: 11108
- Joined: Sun Apr 03, 2005 8:32 pm
- Location: North Dakota
-
Contact:
Post
by Lavoy » Mon Oct 08, 2007 6:32 pm
Gary,
One spring is not necessarily a problem if it is the correct one. Some of my rebuilts come with single springs, but they are a heavier spring to match the pressure of the dual springs. When you installed the pressure plates, did you set the fingers with a clutch gauge?
lavoy
-
kyboy
- 40C crawler
- Posts: 12
- Joined: Thu Sep 13, 2007 5:00 am
- Location: st paul ky
Post
by kyboy » Tue Oct 09, 2007 3:24 am
I didnt have the the guage but, should you be able to compress the fingers between you thumb and forfinger? i had the adjustment most of the way out and could see the cluthes turning when i looked into the housing.i feel there isnt enough pressure on the disks.
gary
-
Lavoy
- Site Admin
- Posts: 11108
- Joined: Sun Apr 03, 2005 8:32 pm
- Location: North Dakota
-
Contact:
Post
by Lavoy » Tue Oct 09, 2007 4:21 pm
If the fingers are down pretty close to the pressure plate frame, you should have push pretty hard with a finger. If they are out a ways, then not so tough.
Lavoy
Who is online
Users browsing this forum: No registered users and 8 guests
