Radiator mounting
- mapaduke@yahoo.com
- 1010 crawler
- Posts: 420
- Joined: Sun Sep 13, 2009 6:27 pm
- Location: Rochester N.H.
Radiator mounting
What's the procedure for using the rivets that comes with the new mounting pads? I've been using machine screws.
nothing crawles like a deere
Grind off the old rivet heads( or unscrew the screws), remove the old rubber mounts. Fit new mounts, placing the all the rivets in the same direction. You will need a proud 1/8 to 3/16" of the rivet sticking through the rubber mount. If they are longer you may have to trim the rivet back a bit with a sidearm grinder. Use an anvil/ scale weight or similar to hold the rivethead and peen the staight end of the rivet with a ball peen hammer. Only takes a few good peens and you are done. Repeat. Take care, Bruce
- Paul Buhler
- 350 crawler
- Posts: 991
- Joined: Wed May 21, 2008 6:25 pm
- Location: Killington, VT
Who is online
Users browsing this forum: No registered users and 150 guests