Fitting a winch to a 40C
- BradE
- 40C crawler
- Posts: 15
- Joined: Tue Apr 03, 2012 11:00 am
- Location: Northeast Kingdom of Vermont
Fitting a winch to a 40C
I am wondering how I could fit a winch to my 40C and use the standard PTO shaft to run it. What winch should I be looking at? (Had an old abused Braden, but it was too far gone to repair) I am assuming I would have to create some sort of bracket to hold the winch in place. Since there can be a lot of force while winching, any thoughts about the weight of the steel framework I'll need to fabricate to hold it in place? I have a Koenig winch on the front of my '50 Jeep, and I could use that one, but I don't think it's rugged enough. Thanks.
JD 40C 4 roll 1955, snow tracks and sprockets from a 350
Who is online
Users browsing this forum: No registered users and 73 guests