Steering clutches for a 1949 JD MC crawler

Post by **Lavoy** » Sat Nov 26, 2016 10:31 am

I might have, there are two different ones, I would need part number.
Lavoy

Flip · Post by **Flip** » Sun Nov 27, 2016 11:12 am

Lavoy
The part number I need is 875T serial number 16835. It is a snap ring with the inside size of1.281 wire size is .130 according to JD

Post by **Lavoy** » Sun Nov 27, 2016 6:01 pm

If Deere has it, that is where I would get it.
Lavoy

jtrichard · Post by **jtrichard** » Sun Nov 27, 2016 6:47 pm

IF Deere dont have them this place does .... Looks like XRC350 page 26 ..I dont know how many you would have to buy BUT some times places like them will tell you who they supply that you can get them from http://www.arconring.com/wp-content/upl ... atalog.pdf HERE is another ( External Ring# 140 ) http://products.ring-masters.net/item/e ... ns/pn-1319

Flip · Post by **Flip** » Sun Nov 27, 2016 7:33 pm

Thank you I checked with Deere and they think they may be able to get but are not sure

Flip · Post by **Flip** » Sun Dec 04, 2016 6:31 pm

Lavoy
Do you sell the template used th adjust the fingers on the steering clutch pressure plate

Post by **Lavoy** » Mon Dec 05, 2016 6:51 pm

I do, $25 + freight.
Lavoy

Flip · Post by **Flip** » Mon Dec 05, 2016 6:55 pm

How can I go about ordering it

Post by **Lavoy** » Mon Dec 05, 2016 6:58 pm

Send me an e-mail to postmaster@jdcrawlers.com with name and address, I will get one ready to go and get you a total.
Lavoy

Flip · Post by **Flip** » Wed Dec 07, 2016 5:44 am

Lavoy
The information should be in your inbox

JDcrawlers Messageboard