John Deere 440IC 3 point draw bar support

General help and support for your Lindeman through 2010 John Deere crawler
Post Reply
User avatar
DukeofDeere
1010 crawler
1010 crawler
Posts: 443
Joined: Wed Oct 26, 2011 7:12 am
Location: Hudsonville Michigan

John Deere 440IC 3 point draw bar support

Post by DukeofDeere » Sat Dec 03, 2016 7:49 pm

How do I remove the 3 point drawbar support?
Bushings in each hole that the bolt goes through.

Thanks,
Duke[/quote]

User avatar
JD430C
1010 crawler
1010 crawler
Posts: 350
Joined: Tue May 03, 2005 11:00 pm
Location: Northfield, Vermont
Contact:

Post by JD430C » Sun Dec 04, 2016 1:07 pm

Most of the ones I have worked on had treads on the bushings so you could tread a bolt into them to remove them. I never had any luck getting them out, ended up unbolting removing a final drive to get that drawbar support off.

Andrew
jds- 450B, 450C, 550, 4020, 3140 MFWD, 5200 MFWD

original possum
1010 crawler
1010 crawler
Posts: 258
Joined: Wed Sep 11, 2013 3:34 pm
Location: Shiner, texas

Post by original possum » Sun Dec 04, 2016 1:26 pm

Chase the threads first. Then put in a bolt through a 3/4" drive socket and pray a lot as you tighten it.
Early 40C w/Yakima toolbar and homebuilt ripper: 350 w/6-way

User avatar
DukeofDeere
1010 crawler
1010 crawler
Posts: 443
Joined: Wed Oct 26, 2011 7:12 am
Location: Hudsonville Michigan

Post by DukeofDeere » Mon Dec 05, 2016 5:51 pm

Thanks for the input!

Duke

Post Reply

Who is online

Users browsing this forum: No registered users and 63 guests