A quick FYI: A short time ago, Lavoy mentioned the thrust washer between the governor and the block. Mine did not have one, but I wasn't sure if I had lost it, of if it simply wasn't there. I ordered one from JD. After receiving it, and comparing it with wear marks, it is obvious that it hasn't been there for at least some run time. The bearing was beginning to mark the block.
If mine was missing, no doubt others will be, too.
GAry
Governor thrust washer
-
- 1010 crawler
- Posts: 353
- Joined: Mon Apr 04, 2005 6:53 pm
- Location: Columbus Ohio
Who is online
Users browsing this forum: No registered users and 147 guests