115 ci engine

General help and support for your Lindeman through 2010 John Deere crawler
Post Reply
Keith-OR
430 crawler
430 crawler
Posts: 64
Joined: Fri Sep 22, 2017 9:35 pm
Location: Hermiston, Oregon

115 ci engine

Post by Keith-OR » Tue Jan 23, 2018 6:28 pm

Here is ready to put problem, I am putting engine back together. I have install crankshaft and installed the cam, BUT cam gear has 2 center punch marks, one is just below the dash mark of the cast numbers and there is 6 teeth between second center punched mark.. So which center punch mark do I use????

Thanks
Keith
Keith

Keith-OR
430 crawler
430 crawler
Posts: 64
Joined: Fri Sep 22, 2017 9:35 pm
Location: Hermiston, Oregon

Re: 115 ci engine

Post by Keith-OR » Tue Jan 23, 2018 8:35 pm

Is that the key way on camshaft? I know it is marked at key way on crankshaft?

Thanks
Keith

Keith-OR
430 crawler
430 crawler
Posts: 64
Joined: Fri Sep 22, 2017 9:35 pm
Location: Hermiston, Oregon

Re: 115 ci engine

Post by Keith-OR » Tue Jan 23, 2018 10:27 pm

Thanks Ralph, I pulled the snap ring on the camshaft, and the punch mark I used on the cam gear happened to be the correct one... I can't figure out why anyone would put a second punch mark on the cam gear. That probably why it wouldn't start when I first bought crawler.
Keith

Post Reply

Who is online

Users browsing this forum: No registered users and 52 guests