I have yet another question about the 2010 crawler? I bought a rebuilt head and installed it with no problems. However the combustion chamber 2 and 3 were leaking some antifreeze around them. I pulled the injector assembly out and didn't have the antifreeze drained low enough and flooded the head, so I pulled the head back off and dried everything out. Put the head back on but now the motor seems to turn over as if it has no back pressure? Also I am getting water seepage between the block and the piston sleeve that is sandwiched between the head and the block itself.
What would be my best bet? Too pull the head and the piston sleave and replace the gasket? I really don't want to mess with the lower end of the motor because I think its ok and I'm learning how to replace the head by trail and error.
Thanks a million for everyones help, I'm slowly learning how to work on a crawler!
2010
Who is online
Users browsing this forum: No registered users and 128 guests