Hey guys, finally got the finals back in action, they seem to work fine. HOWEVER, as I put a load on the machine, the speed slows down. I adjusted the clutch linkage but this did not change the situation.
When I pull the engine, is there anything else to check for. Bearings in the reverser ect. It has a good bit of a "Roar" in 1st and 2nd, can I change any of the transmission bearings from the front? It wants to jump out of 2nd at times.
Thanks for the advice.
Magoo
440 Engine Clutch
440 Engine Clutch
40 C, 60 Row Crop, 420 W, 420 W all fuel, 440 C, two 420 L&G and 1020 Ru Diesel
Who is online
Users browsing this forum: No registered users and 141 guests