It's always something!
- Paul Buhler
- 350 crawler
- Posts: 991
- Joined: Wed May 21, 2008 6:25 pm
- Location: Killington, VT
Re: It's always something!
Progress. Good luck.
Paul Buhler
Killington, VT
420c 5 roll with 62 blade, FOPS, and Gearmatic 8a winch
Killington, VT
420c 5 roll with 62 blade, FOPS, and Gearmatic 8a winch
Re: It's always something!
AHHHHHH!!! Tried using the 1010 yesterday. Ran fine. The hydraulics were a little shaky. Got progressively worse the more I did, an air leak on the suction side I think. No oil leaks to be seen. I have a feeling the new hose I put in is a little too long and is pushing the steel line to the pump enough to let it suck air. I know th line hung down an inch or so and this wasn't happening before I put the pans back on. I'm going to get it up to the shop this time. I'll still be on my back in the cold, but at least I'll be near my tools when i drop the skid pan.
40C, 420C, 1010C-L-BH, Cat D4
Who is online
Users browsing this forum: No registered users and 66 guests