John Deere 1010 Dozer

General help and support for your Lindeman through 2010 John Deere crawler
Post Reply
timr
40C crawler
40C crawler
Posts: 10
Joined: Tue May 04, 2021 3:51 pm
Location: Bridgeport,Ohio 43912

John Deere 1010 Dozer

Post by timr » Fri May 21, 2021 10:27 pm

Edited Lavoy was 100% right about pumping the tube adjuster full of grease to pop out the cylinder, mine was just being a bugger lot of dirt caked on it
Top
User avatar
Lavoy
Site Admin
Site Admin
Posts: 10949
Joined: Sun Apr 03, 2005 8:32 pm
Location: North Dakota
Contact:
Contact Lavoy

Re: John Deere 1010 Dozer

Post by Lavoy » Tue May 25, 2021 9:14 am

I usually take a cylinder hone and clean the inside of the barrel up really well before I put them back together. A layer of anti-seize or something on the part of the piston that is inside the seal up to the cup might help it not stick again.
Lavoy
Parts and restoration for antique and late model John Deere crawlers.
Owner and moderator www.jdcrawlers.com
Top
Post Reply

Return to “Early model JD crawler technical support”

Who is online

Users browsing this forum: Jim B and 127 guests