1010c Sprocket Question
-
- 40C crawler
- Posts: 19
- Joined: Sat Jun 26, 2021 10:52 am
- Location: Alabama
1010c Sprocket Question
Started the process of taking the right final drive off to replace clutch pack. I’ve separated track and lifted right side up. I was ready to take sprocket off but it won’t turn. It’s in neutral. Am I missing something? Can’t get to bottom sprocket bolts with impact because of carriage frame. Should I just remove pinion gear behind quill or can I even do that easily? Suggestions?
- Stan Disbrow
- 350 crawler
- Posts: 2898
- Joined: Fri Jul 15, 2005 3:13 pm
- Location: Raleigh, NC
Re: 1010c Sprocket Question
Hi,
Do you have the opposite track off the ground so it can spin? Crawlers have no differential so both sides are locked together. You can block the opposite side steering stick back to release that clutch pack.
Stan
Do you have the opposite track off the ground so it can spin? Crawlers have no differential so both sides are locked together. You can block the opposite side steering stick back to release that clutch pack.
Stan
There's No Such Thing As A Cheap Crawler!
Useta Have: '58 JD 420c 5-roller w/62 inside blade
Useta Have: '78 JD350C w/6310 outside blade
Useta Have: '68 JD350, '51 Terratrac GT-25
Have: 1950 M, 2005 x495, 2008 5103 (now known as 5045D)
Useta Have: '58 JD 420c 5-roller w/62 inside blade
Useta Have: '78 JD350C w/6310 outside blade
Useta Have: '68 JD350, '51 Terratrac GT-25
Have: 1950 M, 2005 x495, 2008 5103 (now known as 5045D)
-
- 40C crawler
- Posts: 19
- Joined: Sat Jun 26, 2021 10:52 am
- Location: Alabama
Re: 1010c Sprocket Question
No I didn’t. Thanks for the info.
Who is online
Users browsing this forum: No registered users and 116 guests