After about 3 years I am finally reassembling the tracks for my 420 in which lavoy previously installed new pins and bushings. I need to order hardware for my 2 bolt pads. I just realized the parts manual does not give sizing information and the crawler is about 3.5 hours away so I cant easily run out to the barn to measure the old bolts and parts.. Appreciate some recommendations/confirmation of requirements.
My recollection is as follows:
5/8 inch fine thread bolts
1.75 inch bolt length
standard nuts (no washers)
Grade 5 (or do I need grade 8?)
Torque to the limit of the 1/2 inch air impact
Mike
420C track pad bolts
Re: 420C track pad bolts
That is what I do, grade 5 or 8 is personal preference, factory were grade 5.
Lavoy
Lavoy
Parts and restoration for antique and late model John Deere crawlers.
Owner and moderator www.jdcrawlers.com
Owner and moderator www.jdcrawlers.com
Who is online
Users browsing this forum: No registered users and 102 guests