General help and support for your Lindeman through 2010 John Deere crawler
-
Lavoy
- Site Admin
- Posts: 10951
- Joined: Sun Apr 03, 2005 8:32 pm
- Location: North Dakota
-
Contact:
Post
by Lavoy » Mon Feb 26, 2007 9:44 pm
I just posted a pic in the FAQ section that is from a factory service bulletin on how to set steering and engine clutch pressure plates. You should be able to print the image and then you will have it for reference.
Lavoy
Last edited by
Lavoy on Tue Feb 27, 2007 5:04 pm, edited 1 time in total.
-
Howard Yoder
- 1010 crawler
- Posts: 353
- Joined: Mon Apr 04, 2005 6:53 pm
- Location: Columbus Ohio
Post
by Howard Yoder » Tue Feb 27, 2007 4:37 pm
Thanks Lavoy I made a copy and put it in my service manuel.
-
Little John
- 430 crawler
- Posts: 58
- Joined: Wed Aug 03, 2005 5:31 pm
- Location: Westminster, Maryland
Post
by Little John » Thu Mar 01, 2007 8:43 pm
Lavoy, Thanks for the #286 Service Bulletin on use of gauge JD-7. I'll mark mine as indicated, because at my present rate of work I'll probably have lost what memory I have left when I get to reinstalling the steering clutches.
-
Lavoy
- Site Admin
- Posts: 10951
- Joined: Sun Apr 03, 2005 8:32 pm
- Location: North Dakota
-
Contact:
Post
by Lavoy » Fri Mar 02, 2007 10:07 am
You might be able to take the image and save it to your computer. I guess I did not try it, but that is what I hoped would work. If not, e-mail me and I can send it to you.
Lavoy
-
Little John
- 430 crawler
- Posts: 58
- Joined: Wed Aug 03, 2005 5:31 pm
- Location: Westminster, Maryland
Post
by Little John » Fri Mar 02, 2007 10:15 am
Yes Lavoy, I was able to save it to the computer and make a hardcopy. It is a .jpg file.
Who is online
Users browsing this forum: No registered users and 124 guests