General help and support for your Lindeman through 2010 John Deere crawler
-
Pat
- 440 crawler
- Posts: 144
- Joined: Thu Dec 08, 2005 9:14 am
- Location: Jacksonville NC
Post
by Pat » Sat Apr 28, 2007 1:43 pm
Does anyone have a short cut to replacing the O-rings on the lift cylinders of a MC 1000 tool carrier? It appears that I might have to take the cylinders completely off to get the shaft out. Hope there is an easier way. Any input appreciated. Pat
-
Lavoy
- Site Admin
- Posts: 10948
- Joined: Sun Apr 03, 2005 8:32 pm
- Location: North Dakota
-
Contact:
Post
by Lavoy » Sat Apr 28, 2007 7:47 pm
Some times you can get the shaft out. Main thing is to be careful you get it back in the right position as far as the splines are concerned.
Lavoy
-
catmatt
- 40C crawler
- Posts: 24
- Joined: Wed Apr 04, 2007 6:48 pm
- Location: Pennsylvania
Post
by catmatt » Sun Aug 05, 2007 7:19 pm
I am doing/done this to my machine. I was able to get o rings from a local hydraulic shop. I could not imagine getting them apart of the machine!
Who is online
Users browsing this forum: No registered users and 149 guests
