Hi guys,
I just measured my tracks on the old 440 and though my rail height is great, my pins and bushings measure, you guessed it, exactly 100% worn on both sides (23.5 in.). The bushings havn't been turned and I am supprised show very little wear externally(maybe due to the grosely worn sprockets).
My question is, how many hours of operation can you expect from new pins and bushings till you get to 100% worn? I am in the land of sugar sand and nice gravel ( if that makes any difference).
Also, would you expect to get more hours out of the bigger pins and bushings on a 350 track?
Thanks,
Chuck
Pin and bushing wear
Pin and bushing wear
1960 440ICD #461094 w/ #63 manual blade Converted to a gas engine two owners ago.
Who is online
Users browsing this forum: No registered users and 133 guests