Missing adjusting screw

Davie Sprocket · Post by **Davie Sprocket** » Tue Sep 25, 2007 9:53 pm

While looking to adjust the clutch throw out on the right side of the crawler, the adjusting nut that your supposed to attach the 1/2" socket and speed handle to is completely missing. Is there any were i can get this bolt, or can i get a size and length for it.

Dave

Davie Sprocket · Post by **Davie Sprocket** » Tue Sep 25, 2007 10:13 pm

Hope this pic works.

Ray III · Post by **Ray III** » Wed Sep 26, 2007 5:51 pm

Might be in the bottom of the housing, fish around with a magnet?

Post by **Lavoy** » Wed Sep 26, 2007 6:47 pm

It is a 5/16" bolt, 3/4" long give or take, use a good heavy flat washer with it.
Lavoy

Davie Sprocket · Post by **Davie Sprocket** » Wed Sep 26, 2007 7:36 pm

I didn't think of that, i did see a washer in the bottom of there when i was using the flash lite to take the pic. Hopefully getting that set is the only problem.

Thanks guys.

Dave

JDcrawlers Messageboard

Missing adjusting screw

Missing adjusting screw

Who is online