General help and support for your Lindeman through 2010 John Deere crawler
-
FarmLife
- 430 crawler
- Posts: 98
- Joined: Tue Aug 28, 2007 8:55 pm
- Location: Saint Clair, Michigan
-
Contact:
Post
by FarmLife » Tue Oct 16, 2007 3:55 pm
THe engine that came with or MC is a "basket case" and I cannot figure out what is bolted on the front cover of the engine at the end of the cam shaft. It is the opening on the left hand side if looking at the engine from the front. The two holes on the right of the cover are for the crankshaft and governor. Any help would be great, Thanks.
-
FarmLife
- 430 crawler
- Posts: 98
- Joined: Tue Aug 28, 2007 8:55 pm
- Location: Saint Clair, Michigan
-
Contact:
Post
by FarmLife » Tue Oct 16, 2007 9:26 pm
ok I fixed the question, I had my direstions backwards
-
Lavoy
- Site Admin
- Posts: 10948
- Joined: Sun Apr 03, 2005 8:32 pm
- Location: North Dakota
-
Contact:
Post
by Lavoy » Wed Oct 17, 2007 7:34 am
That is where the hyd pump goes.
Lavoy
-
FarmLife
- 430 crawler
- Posts: 98
- Joined: Tue Aug 28, 2007 8:55 pm
- Location: Saint Clair, Michigan
-
Contact:
Post
by FarmLife » Wed Oct 17, 2007 5:33 pm
ok, I will have to put that on the list of parts I need to find, Thanks.
-
Lavoy
- Site Admin
- Posts: 10948
- Joined: Sun Apr 03, 2005 8:32 pm
- Location: North Dakota
-
Contact:
Post
by Lavoy » Wed Oct 17, 2007 6:13 pm
If you are not going to need hyd on the crawler, there is a cover plate that goes over the hole.
Lavoy
Who is online
Users browsing this forum: No registered users and 159 guests