JD440 direction reverser lock pin missing
JD440 direction reverser lock pin missing
I recently bought a JD440IC with a direction reverser that would not latch over into forward. Upon investigation, I found that the lock pin in the forward clutch assembly had “fallen” out of its holder and was therefore not there to hold the adjusting ring in its proper adjustment. My question is this. Does anyone know of any magical way to reinsert the spring and lock pin without disassembling the reverser? I looked at one of my disassembled reversers and it just looks impossible, but I thought if anyone knew of a way to do it, one of you guys would.
JD440-ICD loader; JD440-IC bulldozer; JD440-ICD backhoe; JD440-I backhoe; JD440-I tractor; + five recumbent JD440-ICs
Who is online
Users browsing this forum: No registered users and 102 guests