I have one cracked final housing (T10004T) on my dozer (440IC), and have a chance to get two (T18867T) housings from a 1010. Does anyone know if the housings are interchangable? I would love to get the newer ones as they have the "webbing" in the casting. Just not sure if it is worth a 24 hour drive (round trip) plus the $ for the finals and gas!
Thanks!
Finals from a 1010 destined for a 440?
lizrad 999,
Couldn't find that number in the 440 parts book. I think the 1010 used the same final as the late 440 for a while.This had the large coarse splines on the axle shaft and Bull gear wheras the later 1010 finals I understand had fine splines on the shaft and corresponding gear. Don't know what other differences there are.
Chuck
Couldn't find that number in the 440 parts book. I think the 1010 used the same final as the late 440 for a while.This had the large coarse splines on the axle shaft and Bull gear wheras the later 1010 finals I understand had fine splines on the shaft and corresponding gear. Don't know what other differences there are.
Chuck
1960 440ICD #461094 w/ #63 manual blade Converted to a gas engine two owners ago.
Who is online
Users browsing this forum: No registered users and 84 guests