General help and support for your Lindeman through 2010 John Deere crawler
-
frozendozer
- 430 crawler
- Posts: 80
- Joined: Sat May 12, 2007 11:48 pm
Post
by frozendozer » Tue Jun 02, 2009 3:33 pm
i had to replace the water temp gauge with an after market one, on my jd 440 1cd. the new gauge has a sensor that needs to be in contact with the coolant in the motor.
i cant find where this would be out, does any one have any ideas.
-
larry
- MC crawler
- Posts: 4
- Joined: Mon Aug 25, 2008 5:54 pm
- Location: maine
Post
by larry » Tue Jun 02, 2009 4:59 pm
IT SHOULD GO WERE THE ORIGIONAL WAS. ON MY 40 IT GOES ON THE BACK OF THE HEAD BY THE FUEL TANK. HOPE IT HELPS
LARRY
-
frozendozer
- 430 crawler
- Posts: 80
- Joined: Sat May 12, 2007 11:48 pm
Post
by frozendozer » Tue Jun 02, 2009 6:56 pm
i seen something there, but the original sensor was removed and a plug has been inserted. i wasnt sure if that is the correct spot, but i am gonna check it out
Who is online
Users browsing this forum: No registered users and 85 guests