1010 Final Drive

General help and support for your Lindeman through 2010 John Deere crawler
Post Reply
User avatar
bent
440 crawler
440 crawler
Posts: 113
Joined: Mon Apr 04, 2005 9:05 am
Location: Saskatchewan

1010 Final Drive

Post by bent » Sun Apr 17, 2005 10:05 am

I built a puller (pusher) for the axle according to the service manual. After I removed the pipe plugs, I found that the threaded holes in the bull gear do not line up to allow the threaded legs of the puller to screw in. They are just off ever so much. Has anyone else ever found this?

What about using the 7/16" holes where the cap screws for the quill? Would this be strong enough for this push?

Any other ideas?

bent
:)

Post Reply

Who is online

Users browsing this forum: Google [Bot] and 55 guests