Okay, last night I built a puller. I took a piece of 3/8" steel about 3"x8" and cut holes to match the holes on the bearing quill. I cut the centre out to allow access to the shaft and cut notches into the ends for the legs of my puller. I used 7/16" cap screws and attached the puller legs to the notches on the end of the plate. I added 2 strips of 3/8" welded at right angle to the plate for strength. I made an end for the puller legs and put the port-a-power in, tightened everything up, moved to the other side of the case and three pumps got the axle moving. No hammering, heating or beating.
bent
Axle removal
Who is online
Users browsing this forum: gus and 132 guests