General help and support for your Lindeman through 2010 John Deere crawler
-
norkey
- MC crawler
- Posts: 4
- Joined: Wed Jan 13, 2010 2:04 pm
- Location: Queen PA
Post
by norkey » Mon Jun 07, 2010 7:30 pm
Need alittle help here! I was putting my steering clutch together today on my 440 and after the assembly i hardly have any room on the clutch fingers to set them. Is this normal?
-
Ray III
- 2010 crawler
- Posts: 609
- Joined: Sat Aug 25, 2007 1:39 pm
- Location: Troy, NY
Post
by Ray III » Mon Jun 07, 2010 7:36 pm
Room where? Do you meant the bolts seem too long or too short?
-
norkey
- MC crawler
- Posts: 4
- Joined: Wed Jan 13, 2010 2:04 pm
- Location: Queen PA
Post
by norkey » Mon Jun 07, 2010 8:26 pm
I can only move the adjusting bolt about 3 turns either way. Doesnt seem to give me enough height on the finger for proper adjustment. Everything is new. Do i need to worry about even adjusting the fingers with a new pressure plate and clutch disks?
-
Lavoy
- Site Admin
- Posts: 11108
- Joined: Sun Apr 03, 2005 8:32 pm
- Location: North Dakota
-
Contact:
Post
by Lavoy » Mon Jun 07, 2010 11:52 pm
Pressure plate fingers always need to be adjusted any time the clutch is disassembled and/or parts replaced. Not to say that people don't do it and get by, but it should be done.
Still not sure what you mean by the bolt does not give you enough adjustment.
Lavoy
Who is online
Users browsing this forum: No registered users and 5 guests
