Bo lindeman seat channel

General help and support for your Lindeman through 2010 John Deere crawler
Post Reply
codyg
MC crawler
MC crawler
Posts: 6
Joined: Sun Nov 05, 2006 9:35 pm
Location: tx panhandle

Bo lindeman seat channel

Post by codyg » Wed Jan 26, 2011 4:38 pm

I am looking for a Bo lindeman seat channel or good enough measurements to build one by
Top
User avatar
Willyr
2010 crawler
2010 crawler
Posts: 695
Joined: Sat Jul 17, 2010 3:03 am
Location: Downeast Maine (North of Ellsworth)

Post by Willyr » Thu Jan 27, 2011 8:56 am

Lavoy sells the seat parts. No he wont divulge the secret for us to make our own. LOL

Ultimately I used 6" channel iron for my seat riser.
former owner of a 1956 420c
All help is greatly appreciated.

Proud owner of a project 1952 JD 60

http://www.youtube.com/watch?v=nFehqXVd9z4
Top
User avatar
Lavoy
Site Admin
Site Admin
Posts: 10952
Joined: Sun Apr 03, 2005 8:32 pm
Location: North Dakota
Contact:
Contact Lavoy

Post by Lavoy » Thu Jan 27, 2011 10:18 am

Unfortunately I do not make the Lindeman seat parts, sorry.
Lavoy
Top
Pat
440 crawler
440 crawler
Posts: 144
Joined: Thu Dec 08, 2005 9:14 am
Location: Jacksonville NC

Post by Pat » Fri Jan 28, 2011 8:16 am

Cody, the BO seat channel is made of 3" channel iron. About 30 inches long with about an 80 degree bend at about 10 inches up from the bottom. There are about 1 " center cuts on each end for adjustment. Would probably be easier to call Richy at McGrew Parts (866-521-9515) to see if they are parting out one since Lavoy doesn't have one. Hope this helps. Pat
Top
Post Reply

Return to “Early model JD crawler technical support”

Who is online

Users browsing this forum: Wilbur and 72 guests