General help and support for your Lindeman through 2010 John Deere crawler
-
mikes420c
- 40C crawler
- Posts: 13
- Joined: Tue Apr 12, 2005 6:14 pm
- Location: Jesup Georgia
Post
by mikes420c » Wed Feb 22, 2006 7:04 pm
What size and threads is the nut that screws on the elbow with a strainer that is screwed into carburetor? It looks like 1/4" tubing but only goes on about 1 turn before tighting up which is not enough to compress the ferrule.
-
JD40c
- Site Admin
- Posts: 221
- Joined: Sun Apr 03, 2005 9:14 pm
- Location: Athena, OR
-
Contact:
Post
by JD40c » Wed Feb 22, 2006 7:08 pm
Is too much of the tubing sticking out past the ferrule keeping it from tightening up?
1955 John Deere 40C 4-roller
-
mikes420c
- 40C crawler
- Posts: 13
- Joined: Tue Apr 12, 2005 6:14 pm
- Location: Jesup Georgia
Post
by mikes420c » Wed Feb 22, 2006 7:55 pm
No. The threads just don't feel right. Have not even tried it with a piece of tubing yet. It looks like pipe threads but the John Deere manual shows it as a compression fitting on that end. The end with the strainer is 1/8 pipe threads.
Who is online
Users browsing this forum: No registered users and 115 guests