General help and support for your Lindeman through 2010 John Deere crawler
-
krusty
- 430 crawler
- Posts: 61
- Joined: Fri Apr 08, 2011 12:46 pm
Post
by krusty » Wed Jun 08, 2011 8:11 am
Hey gang,
Hope to get a 40C project this week. Engine runs fine and a steering clutch needs new fiber plates. Also needs a hydraulic cylinder. Just looking for an aftermarket one for now. Anyone know the bore diameter and collapsed and expanded length for it?
No real desire to make it all pretty just very functional!
Krusty.
-
Lavoy
- Site Admin
- Posts: 10955
- Joined: Sun Apr 03, 2005 8:32 pm
- Location: North Dakota
-
Contact:
Post
by Lavoy » Wed Jun 08, 2011 10:27 am
Cylinder size will depend on what the cylinder is being used on, or for. What are you doing with it, might be able to figure it out that way.
Lavoy
-
krusty
- 430 crawler
- Posts: 61
- Joined: Fri Apr 08, 2011 12:46 pm
Post
by krusty » Wed Jun 08, 2011 2:11 pm
would be for a dozer blade though once I remount the blade it should be obvious the length of travel needed.
-
mapaduke@yahoo.com
- 1010 crawler
- Posts: 420
- Joined: Sun Sep 13, 2009 6:27 pm
- Location: Rochester N.H.
Post
by mapaduke@yahoo.com » Thu Jun 09, 2011 5:50 am
I have both the 61,62 Deere blades with deer cylinders on them that I can measure up for you If that is what you have?
nothing crawles like a deere
Who is online
Users browsing this forum: No registered users and 63 guests
