Loader capacity for 2010 track loader

[05victorylly]

Hey guys, I have been searching for a few days and can't seem to locate any info. Its a 1964 JD 2010 track loader. I'll attach a picture. I am mostly looking to figure out how many yards the bucket holds. But any other specs are much appreciated.

[jdemaris]

Hey guys, I have been searching for a few days and can't seem to locate any info. Its a 1964 JD 2010 track loader. I'll attach a picture. I am mostly looking to figure out how many yards the bucket holds. But any other specs are much appreciated.

2010 crawler-loader came with a 1 yard front bucket for normal use and a 1 1/2 yard for "light materials " use.

[Pammark]

I have the operator manual for a 2010 loader. Here are some specs.

Bucket width - 66 1/4"
Bucket vol - 1 cu yd
Bucket lift - 4,500 lbs
Bucket lift height - 115 1/2"
Dump angle up - 50'
Dump angle down - 70'


My 2010 weighed in at 6.5 ton with the bucket and back weights.

I hope this helps.

Mark

[jdemaris]

Hey guys, I have been searching for a few days and can't seem to locate any info. Its a 1964 JD 2010 track loader.

I don't have all the specs on the 2010 crawler loader. But . . since Deere put almost the same size bucket on it as the 450 crawler-loader, I'm going to assume they are comparible. 2010 came with a "normal use" 1 yard bucket and the 450 came with a "normal use" 1 1/8 yard bucket.

350 crawler loader with ¾ yard bucket: front bucket breakout-force = 9000 lbs. front bucket carry capacity 3 feet off the ground = no spec given. Front bucket carry capacity at full height = 4000 lbs

450 crawler loader with 1 1/8 yard front bucket: front bucket breakout-force = 12000 lbs. front bucket carry capacity 3 feet off the ground = no spec given. Front bucket carry capacity at full height = 5500 lbs


1010 crawler loader with ¾ yard bucket: front bucket breakout-force = 8500 lbs. front bucket carry capacity 3 feet off the ground = 7900 lbs. Front bucket carry capacity at full height = 4000 lbs

[05victorylly]

Awesome thanks guys! I assumed it was a 1 yard bucket, but I was not sure. So the 2010 is basically in between a 350 and 450 in size and power?...is that correct?

[jdemaris]

Awesome thanks guys! I assumed it was a 1 yard bucket, but I was not sure. So the 2010 is basically in between a 350 and 450 in size and power?...is that correct?

As far as the crawler-loader 2010 goes - it's got near the same lifitng capacity as a 450 crawler-loader. Has an engine about inbetween a 350 and 450. 350 uses a 135 gas or a 152/164 diesel. A 450 uses a 180 gas or a 202/219/239 diesel. A 2010 uses a 144 gas or a 165 diesel.

350 replaced the 1010 but utilized some of its design and is heavier. 450 replaced and utilized some of the 2010 design and is also heavier.

[Tigerhaze]

Hey guys, I have been searching for a few days and can't seem to locate any info. Its a 1964 JD 2010 track loader. I'll attach a picture. I am mostly looking to figure out how many yards the bucket holds. But any other specs are much appreciated.

This thread has a number of specs for the 2010 crawlers, especially on Page 2.

http://www.jdcrawlers.com/messageboard/ ... c&start=15