Hello everyone, hope all of you had a great turkey day,
I found out why the hyd sys is slow, the suction side is resricted,someone used a rubber line off the pump, half kinked and at the tank end the nut is tight but line is'nt, should this be a one piese line?
49-MC HYD LINE
- Dave Auger
- 40C crawler
- Posts: 11
- Joined: Mon Nov 05, 2012 6:23 pm
- Location: MARLBORO MA
Should be a one piece steel line. Nut at the tank is not a bid deal, the suction part of the line should be below the oil level.
Lavoy
Lavoy
Parts and restoration for antique and late model John Deere crawlers.
Owner and moderator www.jdcrawlers.com
Owner and moderator www.jdcrawlers.com
- Dave Auger
- 40C crawler
- Posts: 11
- Joined: Mon Nov 05, 2012 6:23 pm
- Location: MARLBORO MA
MC HYD LINE
HI, I'm looking for a hyd line for a mc , from the hyd tank to the pump,the parts man. # is key#9--part#m1346t Thank's Dave
MC hydraulic suction line
I had same problem, I cut the existing piece of steel and shoved a piece of hydraulic hose over the steel , at the ends and used 2 hose clamps per end, works fine on my MC
- Dave Auger
- 40C crawler
- Posts: 11
- Joined: Mon Nov 05, 2012 6:23 pm
- Location: MARLBORO MA
Who is online
Users browsing this forum: No registered users and 70 guests