General help and support for your Lindeman through 2010 John Deere crawler
-
sam
- 420 crawler
- Posts: 33
- Joined: Mon May 29, 2006 12:43 pm
- Location: La
Post
by sam » Mon May 29, 2006 1:52 pm
I have a full set of 440 rollers rebuildable. Does anyone have ideas for removing the set scews broken off to deep to cut screw driver slots and heat.
-
Lavoy
- Site Admin
- Posts: 10951
- Joined: Sun Apr 03, 2005 8:32 pm
- Location: North Dakota
-
Contact:
Post
by Lavoy » Mon May 29, 2006 6:18 pm
Set a 5/16" nut on top of the broken set screw, and carefully weld down through the center and weld it to the top of the set screw. Let cool and see if it will back out. I have done more this way than I can remember.
Lavoy
Who is online
Users browsing this forum: No registered users and 147 guests