420 ring and pinion
420 ring and pinion
I tore the ring gear loose from the hub recently and as I have been working on it I was wondering if I'm to hard on the machine or was it just time for it to go? Every bolt hole in the hub is broke out. All I done was put in in reverse to back up and it made a crunch noise and it was done.
Depending on serial number, there were some changes to the carrier I believe. I have had several with the ring welded to the carrier. I have also torn some down that had the bolts loose, and the dowels hammered a little bit. When you put it back together, make sure the dowels are tight, and Loctite them in, as well as the bolts.
Lavoy
Lavoy
Who is online
Users browsing this forum: No registered users and 142 guests