axle

General help and support for your Lindeman through 2010 John Deere crawler
Post Reply
User avatar
Eric.MacLeod
440 crawler
440 crawler
Posts: 120
Joined: Sun Feb 10, 2008 9:15 pm
Location: wells,maine

axle

Post by Eric.MacLeod » Sun May 25, 2014 10:26 am

hello, I have the axles out of my boys 420 dozer, they are worn around the seal surface. I have seen people repair them with a reddi- sleeve and I would like to do this to.does anyone have a part number or any recommendations? thank you.Eric.
Top
User avatar
Lavoy
Site Admin
Site Admin
Posts: 10942
Joined: Sun Apr 03, 2005 8:32 pm
Location: North Dakota
Contact:
Contact Lavoy

Post by Lavoy » Sun May 25, 2014 8:33 pm

Tough to do on a 420, you have to cut the sleeve back pretty far to make sure it does no interfere with the bearing. Did it once, it just split the sleeve in two because I did not cut it back far enough.
Lavoy
Parts and restoration for antique and late model John Deere crawlers.
Owner and moderator www.jdcrawlers.com
Top
User avatar
gregjo1948
350 crawler
350 crawler
Posts: 1000
Joined: Mon Aug 30, 2010 5:58 am
Location: Newark Valley,NY,USA

Post by gregjo1948 » Mon May 26, 2014 5:30 am

How about spray welding? gregjo1948
JD 350B diesel 6way blade, Case 580B Loader/backhoe, Farmall 504 high crop w/ flail boom mower, International 404 , International 284 diesel w/belly mower, 1972 Ford F600 dump truck, Galion 3-5 roller, Allis Chalmers D17, 1620 Ford
Top
User avatar
Lavoy
Site Admin
Site Admin
Posts: 10942
Joined: Sun Apr 03, 2005 8:32 pm
Location: North Dakota
Contact:
Contact Lavoy

Post by Lavoy » Mon May 26, 2014 9:10 am

That is what I use, pretty much only thing as far as that goes.
Lavoy
Parts and restoration for antique and late model John Deere crawlers.
Owner and moderator www.jdcrawlers.com
Top
Post Reply

Return to “Early model JD crawler technical support”

Who is online

Users browsing this forum: No registered users and 28 guests