Model 420 hydraulic blade question.

mc40joe · Post by **mc40joe** » Thu Oct 23, 2014 8:36 pm

Is there an adjustment on the control valves so you may stop blade at any height?

Post by **Lavoy** » Thu Oct 23, 2014 9:55 pm

Not sure I understand the question? When you let go of the hyd lever, the blade should stop moving no matter where it is at.
Lavoy

mc40joe · Post by **mc40joe** » Fri Oct 24, 2014 7:25 am

when you let go of the handle unless it at the top it goes back down. model 420 c with heavy duty blade

Post by **Lavoy** » Fri Oct 24, 2014 8:17 am

Usually that is bad cylinder seals, either way, not a setting on the valve.
Lavoy

mc40joe · Post by **mc40joe** » Fri Oct 24, 2014 11:48 am

thank you it has two cylinders on it should both be rebuilt

Stan Disbrow · Post by **Stan Disbrow** » Fri Oct 24, 2014 2:07 pm

Hi,

Yes, since each cylinder only has about the capacity to lift half of the blade weight on a 62 (the model number of the bulldozer attachment).

Stan

mc40joe · Post by **mc40joe** » Fri Oct 24, 2014 2:26 pm

thank you for the help are there kits for them from deere or any one you know

Post by **Lavoy** » Fri Oct 24, 2014 4:03 pm

Check with a local hyd shop, if not, give me a call.
Lavoy

mc40joe · Post by **mc40joe** » Sat Oct 25, 2014 8:13 am

OK THANK YOU FOR YOUR HELP

JDcrawlers Messageboard

Model 420 hydraulic blade question.

Model 420 hydraulic blade question.

Who is online