John Deere 440IC crankshaft
John Deere 440IC crankshaft
I am needing a crankshaft for a 440IC gas track loader. My crank is a M3114T. Will other cranks from say an MT fit? I see other info that says this is the same motor as this or that but would like to clarify the difference or should I be looking for only this P/N. If someone has one for sale I would be interested. I also need the seal cap for the big end of the crank as well as a starter ring gear. Thank you in advance for the help. I know I have found the right place to get some answers. I know I will have more.
Other than two cylinders, not the same engine as M.
I should have a crank on hand, ring gear is no problem not sure about rear seal holder, would have to dig.
Welcome to the board.
Lavoy
I should have a crank on hand, ring gear is no problem not sure about rear seal holder, would have to dig.
Welcome to the board.
Lavoy
Parts and restoration for antique and late model John Deere crawlers.
Owner and moderator www.jdcrawlers.com
Owner and moderator www.jdcrawlers.com
Who is online
Users browsing this forum: No registered users and 37 guests