440 6way hydraulic blade

gregjo1948 · Post by **gregjo1948** » Mon Mar 30, 2015 4:17 am

Will a 6way hydraulic blade with frame and cylinders from a 440 mount on a 1010 without altering or fabricating it to fit? Thanks, gregjo1948

Post by **Lavoy** » Mon Mar 30, 2015 7:43 am

I believe it will for the most part. I did it the other way, and had some small issues. Also it lifts too high and hits the grille.
Lavoy

gregjo1948 · Post by **gregjo1948** » Mon Mar 30, 2015 8:01 am

Thanks Lavoy!! I'm looking at it to buy and it has 3 control levers which seems like that could keep your right hand real busy if you use your right hand to steer right also. gregjo1948

Post by **Lavoy** » Mon Mar 30, 2015 1:42 pm

That's a little odd, normally two left hand levers on their own valve for angle and tilt, and then the crawler hyd on the RH for lift.
Lavoy

wizner85 · Post by **wizner85** » Sat Apr 11, 2015 12:43 pm

Good to meet you Greg. I appreciate the Business. Make sure you post some pics when it is done.

gregjo1948 · Post by **gregjo1948** » Sun Apr 12, 2015 4:05 am

wizner85 wrote:Good to meet you Greg. I appreciate the Business. Make sure you post some pics when it is done.

I'd be happy to post pictures but, I don't know how! gregjo1948

JDcrawlers Messageboard

440 6way hydraulic blade

440 6way hydraulic blade

Who is online