Parts, Services, and For-Sale
-
JD430C
- 1010 crawler
- Posts: 350
- Joined: Tue May 03, 2005 11:00 pm
- Location: Northfield, Vermont
-
Contact:
Post
by JD430C » Fri Jan 19, 2007 5:23 pm
i have a set of 1010 4 roll tracks for sale. will fit the 420-440, but wont be original. pads are worn pretty good, but rails and pins and bushings looked good. i will check tomorrow to make sure they are. local pickup only, but i can help trucking. asking 500 for both.
johndeere430c@yahoo.com
andrew
jds- 450B, 450C, 550, 4020, 3140 MFWD, 5200 MFWD
-
hunter41mag
- 440 crawler
- Posts: 126
- Joined: Tue Apr 12, 2005 7:11 am
- Location: Eastern Pennsylvania (NE of Allentown)
Post
by hunter41mag » Mon Jan 22, 2007 12:02 pm
Andrew,
Did they make the 1010 in a 4 roller setup? I thought that 440 on up were all 5 roller.
Don
Eastern PA
440IC
-
Lavoy
- Site Admin
- Posts: 10951
- Joined: Sun Apr 03, 2005 8:32 pm
- Location: North Dakota
-
Contact:
Post
by Lavoy » Mon Jan 22, 2007 12:45 pm
It was an option, although at that time I believe not a very popular one. Might have been more prevalent on the Ag crawlers, but not many of them built either.
The 4 bolt rails also became the replacement part for 420 and 430, so there was another possible source there.
Lavoy
-
JD430C
- 1010 crawler
- Posts: 350
- Joined: Tue May 03, 2005 11:00 pm
- Location: Northfield, Vermont
-
Contact:
Post
by JD430C » Mon Jan 22, 2007 1:54 pm
Don, yes u could get 1010s and even early 350s with 4 roll undercarriages. i have seen several up this way. if u look in the photo section and the home page of this site u will see a 1010 4 roller. IMO they look kinda dorky
andrew
jds- 450B, 450C, 550, 4020, 3140 MFWD, 5200 MFWD
-
wwattson
- 1010 crawler
- Posts: 499
- Joined: Mon Aug 07, 2006 9:12 pm
- Location: West Bend, WI
Post
by wwattson » Mon Jan 22, 2007 4:17 pm
Hey, hey, hey, that's my crawler you're talking about! Beauty is in the eye of the beholder.
Bill Wattson
Who is online
Users browsing this forum: No registered users and 97 guests