Parts, Services, and For-Sale
-
reb
- 40C crawler
- Posts: 24
- Joined: Sun Jul 29, 2007 8:42 pm
- Location: Nebraska
Post
by reb » Fri May 02, 2008 9:04 am
I am looking for a pto shaft and related parts for my 450C crawler loader. It currently has just a block plate where the shaft goes. The JD part number for the shaft is : T20948 SHAFT,POWER
Thanks, Ross
-
JD430C
- 1010 crawler
- Posts: 350
- Joined: Tue May 03, 2005 11:00 pm
- Location: Northfield, Vermont
-
Contact:
Post
by JD430C » Fri May 02, 2008 9:57 pm
hi, i have a 450C parts tranny with the pto shaft, if i still need one let me know and i will try to take it apart this weekend.
andrew
jds- 450B, 450C, 550, 4020, 3140 MFWD, 5200 MFWD
-
reb
- 40C crawler
- Posts: 24
- Joined: Sun Jul 29, 2007 8:42 pm
- Location: Nebraska
Post
by reb » Fri May 02, 2008 10:05 pm
Andrew,
I need the shaft and related parts(the outer bolt on housing etc) to convert my non pto 450c. What would you want for the parts? Thanks, Ross
-
jbrown
- 40C crawler
- Posts: 15
- Joined: Thu Feb 14, 2008 9:08 am
Post
by jbrown » Fri Aug 01, 2008 5:51 am
Did you ever put that pto shaft in your dozer? f so how hard was it ,in the service manual its says you have to pull motor. is that so?
-
digitup2
- 350 crawler
- Posts: 858
- Joined: Tue Feb 05, 2008 6:36 pm
Post
by digitup2 » Sat Aug 02, 2008 6:57 pm
Last couple I installed I backed it up on a 8 inch log and pulled the back plate then installed the shaft ,If you get the rear up high enough [a foot even ]you will not lose any oil and you can work on it easyer even .Digitup.
Who is online
Users browsing this forum: No registered users and 124 guests
