I have just had 9 of these large nuts made at a local machine shop and have 5 extras. I know they will fit a 420 4 roller (what I have) and I assume they cary over in different runs.. maybe Lavoy can help me out with that one.
Anyways these are the 2" hex that centers the idler side of the large springs. I had 2 that were beyond salvage with rot and such so I had some made up. If anyone is interested let me know. I have right at $20.00 each in them between machine shop cost and material cost. I'm not looking to make any money on these, just looking to help others out there that either need new ones for a restoration or would just like to have some.
You can see the one nut in the back as a new washer on it from Deere.
Either send a PM or an E-mail to me at JamesRColeJr@gmail.com if you are intersted.
Jimmy in NC
FS: Tension Spring Nuts - JD Part M 3306 T
- Jimmy in NC
- 440 crawler
- Posts: 164
- Joined: Fri Apr 22, 2005 10:44 pm
- Location: Raleigh - NC
FS: Tension Spring Nuts - JD Part M 3306 T
1957 420C 4 roller 4 spd #61 blade 107,xxx ser.
Hand clutches, not for everyone.
Steering clutches, for even less.
Hand clutches, not for everyone.
Steering clutches, for even less.
- Jimmy in NC
- 440 crawler
- Posts: 164
- Joined: Fri Apr 22, 2005 10:44 pm
- Location: Raleigh - NC
Who is online
Users browsing this forum: No registered users and 61 guests