Need a dimension on a "new" condition part

Discuss non-crawler related issues here (keep it sane, please)
Post Reply
User avatar
T.Banttari
MC crawler
MC crawler
Posts: 6
Joined: Tue Oct 07, 2014 8:10 am
Location: Shafer, MN

Need a dimension on a "new" condition part

Post by T.Banttari » Sun Feb 18, 2018 11:24 am

I am just finishing the programming and machine setup for making the front idler Guide(s) for my 1010's; P/N is T10028T or T16670T. I am looking for the "step" dimension from a new, or like new part. All I have are used worn parts and I measure the step at about 0.450".
I am making them from AR400 plate along with new front track frame rails of the same material to complete the rebuild of 3 sets of track frames.
Thanks.
4-1010's:1 w/6 way blade;2 w/810-820 loaders; 1 w/outside 60" blade.
350straight Type T4F3D 087066T w/95 backhoe
580K Case TLB 4wd w/ extendahoe;1987; 1150B Case track loader,1969.
CAT15 crawler,1929 ;CAT D2 w/straight blade early50's

User avatar
T.Banttari
MC crawler
MC crawler
Posts: 6
Joined: Tue Oct 07, 2014 8:10 am
Location: Shafer, MN

Re: Need a dimension on a "new" condition part

Post by T.Banttari » Mon Feb 19, 2018 7:55 pm

Thanks Ralph for confirming; With that inside radii and the wear off at an angle, it was difficult to get a good number from the used ones.
TB

Post Reply

Who is online

Users browsing this forum: leadfoot1954 and 3 guests