Oil pump removal

Discuss non-crawler related issues here (keep it sane, please)
Post Reply
jbloam
40C crawler
40C crawler
Posts: 19
Joined: Sun Nov 18, 2018 4:42 pm
Location: Elk County, PA.

Oil pump removal

Post by jbloam » Mon Nov 19, 2018 12:04 pm

I have read this forum as I was looking to buy a dozer. I ended up with a 350 straight to clear a small lot for a house and driveway. My question however has to do with a Deere 410 backhoe I am doing an in frame rebuild on. It has the 4219 engine which I beleive is common to Deere dozers also. So I am hoping for some advice. I cannot get the gear off of the oil pump shaft to be able to remove the oil pump. I cannot acces the front main bearing without removing the oil pump. There is no room for a gear puller . I have tried prybars and wedging a grade 8 bolt with a nut between the shaft end and the frame then turning the nut to force the bolt against the shaft. No luck. Any suggestions would be appreciated.

Post Reply

Who is online

Users browsing this forum: No registered users and 8 guests