New to me 1010

cdndozer · Post by **cdndozer** » Mon Dec 14, 2009 4:35 pm

ok so some bad news after getting the 1010 unstuck,I was walking it back to my trailer to drain the fluids and it threw a rod through the block on the front cylinder.
I have been doing some research in looking for a 1010 deisel engine but no luck...........So what would this go for as a whole parts machine?
Canadian prices please.

KenP · Post by **KenP** » Mon Dec 14, 2009 7:23 pm

deleted

cdndozer · Post by **cdndozer** » Mon Dec 14, 2009 9:29 pm

Yes...Definately a heartbreaker

I ended up buying a D2 to yank it out of the hole I sank it in.Back end sank about 30".
The machine is on my property 1.5 hours from my house all work done on it is laying outside in a field,so even trying to pull the motor and replacing it would be quite difficult,especially without block and tackle or another loader.The D2 I have is a dozer.
Also being in Manitoba,Canada make things a little harder to find and ship.

Thanks.

cdndozer · Post by **cdndozer** » Mon Dec 14, 2009 9:40 pm

some pics,stuck and just after getting it out.As far as 1010's I think I should have put some grousers on it before I ventured into the bush.

JDcrawlers Messageboard

New to me 1010

Who is online