Show us pictures of your JD crawler and attachments.
They are 12" stroke but could have used 10". The tilt is a 6" stroke. I took the time to draw it all up in 3d cad before I built it. I used 12" but didn't like how close to the center they hit if I set them up for full stroke in both directions. The way the are now it hits full on extension but is 2inches from fully collapsed on the collapsed cylinder. I should have a mechanical stop on the blade frame at full tilt but I don't use the angle much and haven't got around to it.
Who is online
Users browsing this forum: No registered users and 4 guests