This is the hitch/pto that I picked up with a bunch of other stuff at auction.
350 3 pt.
-
- MC crawler
- Posts: 9
- Joined: Thu May 26, 2005 3:48 am
- Location: Whitefield, ME
- Contact:
-
- MC crawler
- Posts: 9
- Joined: Thu May 26, 2005 3:48 am
- Location: Whitefield, ME
- Contact:
All I really need is the output shaft and housing. (I think) Am I correct in assuming that all I need to do is remove the "cap" and install the shaft/housing? The pto shifter is in place but I've never checked to see if it did anything yet.
I was surprised at the lengh of the shaft. (In Peter's pic) Too blurry to tell but is the long narrow part just a pilot? I was going to make a machined weldment for the bearing housing and make a shaft but I haven't been able to locate specs on the shaft. Just blury pictures and people that want to $ell the whole kit.
I was surprised at the lengh of the shaft. (In Peter's pic) Too blurry to tell but is the long narrow part just a pilot? I was going to make a machined weldment for the bearing housing and make a shaft but I haven't been able to locate specs on the shaft. Just blury pictures and people that want to $ell the whole kit.
JD420C, Ford 3910, IH 2606, Kenbota G32XKS
Who is online
Users browsing this forum: No registered users and 44 guests