Good morning.
Looking for replacement parts for our 350B reverser. Specificially the Forward Clutch Spider.
We lost the bearing cone and it did some damage to the spider as well as torqued the shaft on the spider.
I appreciate the knowledge that we have found on this site - has been invaluable to our project.
Thanks for any help or insight.
Todd.
350B Reverser Parts
-
- MC crawler
- Posts: 3
- Joined: Mon Jan 30, 2012 4:17 pm
- Location: New Hampshire
i dont think Lavoy does much with 350s so since your in NH i would ask if you tried PB&H in Antrim they are very good guys and have i big inventory of parts. Tell them Frank sent you as i work right down the road from the(at least i was working there until winter layoff. good luck
scampr 440icd, 350B, 47 Farmall H, 55 Farmall cub and ashamed to have a Kabota too
-
- MC crawler
- Posts: 3
- Joined: Mon Jan 30, 2012 4:17 pm
- Location: New Hampshire
I have new stuff available for 350, just no used. There are some reverser parts new that I can get, unfortunately no one is making the spider yet.
Lavoy
Lavoy
Parts and restoration for antique and late model John Deere crawlers.
Owner and moderator www.jdcrawlers.com
Owner and moderator www.jdcrawlers.com
sorry Lavoy didnt want to step on your toes. Didnt know you had 350 too.. and if you remember i asked about a reverser.. i havent forgotten you but until i have a paycheck coming in again I have to put the 440 on the back burner .
scampr 440icd, 350B, 47 Farmall H, 55 Farmall cub and ashamed to have a Kabota too
Not a problem.
I wish I could get the spider, discussed it a time or two with a supplier, but evidently just to much machining involved to make it viable. Either that, or nobody replaces them that much. The output shaft is available, but I know spline wear is a big factor on them.
Lavoy
I wish I could get the spider, discussed it a time or two with a supplier, but evidently just to much machining involved to make it viable. Either that, or nobody replaces them that much. The output shaft is available, but I know spline wear is a big factor on them.
Lavoy
Parts and restoration for antique and late model John Deere crawlers.
Owner and moderator www.jdcrawlers.com
Owner and moderator www.jdcrawlers.com
Who is online
Users browsing this forum: No registered users and 75 guests