350B Reverser Parts

RottenRock · Post by **RottenRock** » Fri Jan 04, 2013 9:54 am

Good morning.

Looking for replacement parts for our 350B reverser. Specificially the Forward Clutch Spider.

We lost the bearing cone and it did some damage to the spider as well as torqued the shaft on the spider.

I appreciate the knowledge that we have found on this site - has been invaluable to our project.

Thanks for any help or insight.

Todd.

scampr · Post by **scampr** » Fri Jan 04, 2013 11:12 am

i dont think Lavoy does much with 350s so since your in NH i would ask if you tried PB&H in Antrim they are very good guys and have i big inventory of parts. Tell them Frank sent you as i work right down the road from the(at least i was working there until winter layoff. good luck

RottenRock · Post by **RottenRock** » Mon Jan 07, 2013 10:06 am

Scampr - Thanks for the information. I will be calling them today.

Best.

Post by **Lavoy** » Mon Jan 07, 2013 4:24 pm

I have new stuff available for 350, just no used. There are some reverser parts new that I can get, unfortunately no one is making the spider yet.
Lavoy

scampr · Post by **scampr** » Mon Jan 07, 2013 5:04 pm

sorry Lavoy didnt want to step on your toes. Didnt know you had 350 too.. and if you remember i asked about a reverser.. i havent forgotten you but until i have a paycheck coming in again I have to put the 440 on the back burner .

Post by **Lavoy** » Mon Jan 07, 2013 9:49 pm

Not a problem.
I wish I could get the spider, discussed it a time or two with a supplier, but evidently just to much machining involved to make it viable. Either that, or nobody replaces them that much. The output shaft is available, but I know spline wear is a big factor on them.
Lavoy

JDcrawlers Messageboard

350B Reverser Parts

350B Reverser Parts

Who is online